Turning On The Station; 42 5.7 Language Selection; 42 5.8 Unit Of Measurement Selection; Setting The Date And Time - Bosch ACS 753 Originalbetriebsanleitung

5.6

Turning on the station

1. Connect the power cable to the socket on the
station and to a outlet with the correct voltage,
equipped with grounding.
i
Do not use a power cable with inadequate charac-
teristics.
2. Place the station so that the plug and power switch
are at the operator's reach.
3. Make sure that the ventilation grille, on the left of
the station, is not obstructed.
4. Lock the front wheels.
5. Turn the power switch on/off lever clockwise to
turn on the station.
"
The first time that the station is switched on, the
Initial Setup mode starts automatically. The software
displays the license agreement after the language
selection, this must be accepted by the user with
5.7 Language selection
Choose the user interface language. The default lan-
guage is English.
1. Use the Up or Down arrow button to scroll through
the available languages, one line at a time.
2. Select
to set the selected language.
5.8 Unit of measurement selection
Set the units of measurement to be displayed. The
default ones are metric units.
1. Use the Up or Down arrow button to select be-
tween the metric or British imperial system.
2. Select
to make the unit of measurement dis-
played effective.
5.9

Setting the date and time

Use the arrow buttons to move the cursor. Use the
keypad to change the displayed information.
1. Use the Up or Down arrow buttons to change the
item displayed: day, month, year, or time.
2. Use the multi-touch interface on the numeric key-
pad to change the information.
3. Select
to save.
Robert Bosch GmbH
Initial settings | ACS 753 | 53 |
5.10

Print header change

The information loaded in Print header change will
appear on each print.
1. Enter the text using the arrow buttons and the
multi-touch interface on the numeric keypad:
+
the button acts as a backspace key.
+
The Right or Left arrows button moves the cur-
sor to the right or left.
+
The Zero (0) key also acts as a space bar.
+
To navigate within the rows, use the Up and
Down arrow keys.
2. Select
to save.
5.11

Automatic internal cleaning

At this point the station cleans its inner hoses before
proceeding with the settings.
1. Check the oil level in the vacuum pump through the
indicator.
.
1
Fig. 15: Checking the vacuum pump oil level
1 Open at the back of the station, to check the oil level through
the inspection port
2. When the message is displayed, connect the station
service hoses to the connections.
3. Open the service hose connections turning the ring
nuts clockwise.
4. Select
.
"
The station cleans its internal hoses and then emits
a beep when the process is completed.
en
|
1 689 989 612 2020-12-01