Operation; Docking; Maintenance; Replacement Of Components - Bosch Rexroth PRC7000 MGDM Betriebsanleitung

R911381901 | Rexroth PRC7000 MGDM Bosch Rexroth AG 113/118

20 Operation

Please note the instructions on operation of the product in section 2 and 3.4.
If at the MGDM LEDs are no faults, then is the MGDM ready.
Refer to the section 16 for the meaning of the LEDs.
The LEDs US1, UD2, PWR and MS should be on the status green.

20.1 Docking

To ensure a safe start-up, the MGDM must be docked without voltage.

21 Maintenance

Check terminal and clamp connections of all cables for damages
and firm sit. Replace defective parts immediately.

21.1 Replacement of components

The replacement of components is reserved to authorisized staff
(trained maintenance staff or field service).

22 Disposal

22.1 Recovery of materials

The products manufactured by us can be returned to us free of charge
for proper disposal.
However, the following conditions have to be satisfied for this purpose:
• no deposits such as oil, grease or other contamination
• no inappropriate extraneous materials or third-party components included.
The packaging materials are made of cardboard, wood and polystyrene.
For environmental reasons, please do not return any empty packagings
to us. They can be easily recycled.
The products are to be sent postage prepaid to the following address:
Bosch Rexroth AG
Bürgermeister-Dr.-Nebel-Straße 2
D-97816 Lohr am Main
Germany

22.2 Recycling

Principal components of our electronic equipment:
• Steel, aluminum, copper, plastic materials.
Due to their high metal content, most of the materials of our products