Operation; Connection Diagram - Bosch KTS 5a Serie Originalbetriebsanleitung

en | 18 | KTS 560 / 590 (KTS 5a Series) | Device description
USB LED Function
Off No data communication via USB.
Flashing green Data communication via USB.
BLUETOOTH LED Function
Off No data communication via Bluetooth.
Flashing green Data communication via Bluetooth.
DIAGNOSTICS LED Function
Off No data communication with control unit.
Green light Data communication with control unit.
"Recovery mode" key
i
The "Recovery Mode" key is only used to perform
a firmware update of KTS 560 / 590 in the case of
malfunctions.
After the "Recovery Mode" key is pressed > 3 seconds,
the ERROR LED lights up red and the firmware can be
updated via DDC (Diagnostic Device Configuration). Af-
ter a firmware update, the ERROR LED must extinguish.
If the firmware is not updated after the "Recovery
mode" key is pressed, the voltage supply and the USB
connecting cable must be disconnected. After the volt-
age supply is reconnected, the ERROR LED must be off
again.
3.6

Operation

The KTS 560 / 590 can be connected to a PC/laptop
by way of a radio link (Bluetooth) or the USB interface.
For a radio link, the Bluetooth USB adapter has to be
plugged into the PC/laptop.
i
The radio link between the KTS 560 / 590 and the
PC/laptop can only be established using the Blue-
tooth USB adapter included in the scope of delivery.
i
In the event of problems with the Bluetooth wireless
connection, refer to the information in sec. 2.5.
i
The Bluetooth USB adapter supplied is not required
for a DCU 100 / 130 / 220 with internal Bluetooth
hardware.
!
Bosch computer with operating system Windows 7,
fitted, for instance, in BEA 850/950 or FSA 740/760
in the trolley have to use the USB 3.0 port for the
Bluetooth USB adapter. If a different Bluetooth USB
adapter is plugged in, proper operation of the USB
functionality cannot be guaranteed.
|
1 689 989 223 2019-03-04
3.6.1

Connection diagram

9
8
7
6
Abb. 6: Connection diagram for the KTS 590 as example
1 OBD interface in motor vehicle
2 OBD connection cable
3 Measurement cables
4 Measurement cables (KTS 590)
5 Power supply unit
6 KTS 590
7 USB connection cable
8 Bluetooth USB adapter for USB 3.0
9 PC (Laptop)
!
Use measurement cables for measurements smaller
than 60 VDC, 30 VAC or 42 VACpeak only.
Only use accessories on circuits that are
not connected to line voltage. The enclosed
accessories must only be used with Bosch
products, and at voltages below the voltage
value as imprinted on the accessories. When
combining accessories, it must be ensured
that the lowest voltage value imprinted on the
accessories is not exceeded.
!
The OBD connection cable (1 684 465 755) included
in the scope of delivery must only be connected to
KTS 560 / 590 and not to any other KTS modules.
1 2
3
4
5
Robert Bosch GmbH