Led Status; Functional Description; Explanation Of Terms; Exhaust Gas Sampling Probe - Bosch BEA 070 Originalbetriebsanleitung

en | 20 | BEA 070 | Product description
3.6

LED status

LED1
Off
Alternate orange and green
flashing at one-second inter-
vals
Rapid alternate orange and
green flashing
Rapid alternate orange and
green flashing (Bosch Emissions
Analysis software not started)
Red light
LED2 (only with battery pack
special accessory)
Off
Green flashing at one-second
intervals
Orange flashing at one-second
intervals
Red flashing at one-second in-
tervals
Green light
Orange light
Rapid green flashing
Red light
3.7

Functional description

The BEA 070 records the absorption coefficients k [m
] of the exhaust gas in compression ignition (diesel)
1
engines. To achieve this, some of the exhaust gas from
the tailpipe of the vehicle is conveyed via an exhaust
gas sampling probe and sampling hose to the measu-
ring chamber (without assisted suction ) while the
vehicle is accelerated freely.
The opacity, which is calculated from the absorption
coefficient, is measured.
3.7.1

Explanation of terms

The effective optical path length is the path of light
through which the exhaust gas flows. It measures
215 mm.
The opacity [%] and the absorption coefficient [m
are a measure of the quantity of light that is absorbed
by soot, white smoke and blue smoke.
The mass concentration [mg/m
ty of particulates in mg that are emitted by the diesel
vehicle for every 1 m of exhaust gas.
3
i
The basis for conversion of the absorption coef-
ficient into mass concentration is the conversion
table established by the British Motor Industry
Research Association (MIRA).
|
1 689 989 113 2020-06-24
Status
BEA 070 off
BEA 070 on and ready
for operation
USB or Bluetooth communi-
cation with Bosch Emissions
Analysis software
Defective firmware
BEA 070 defective
Status
BEA 070 off
Battery capacity between
80 % and 100 %
Battery capacity between
10 % and 80 %
Battery capacity less than 10 %
Battery capacity between
80 % and 100 % (supply via
power supply unit or charging
station)
Battery capacity less than
80 % (supply via power supply
unit or charging station)
Maintenance mode
Problem
-
]
-1
] indicates the quanti-
3
3.7.2

Exhaust gas sampling probe

The exhaust gas sampling probes are designed such
that exhaust gas can be sampled in all types of ex-
haust pipe. An adjusting mechanism ensures a mini-
mum insertion depth of 5 cm in the exhaust pipe.
Furthermore, the design guarantees a minimum dis-
tance of 10 mm from the inside wall of the exhaust
pipe.
3.7.3

Measuring chamber

For measuring opacity, a transmitter (LED) emits a
green light, which is partially absorbed by the exhaust
gas in the measuring chamber.
The proportion of light that is not absorbed reaches
the receiver (photo diode), and converts the optical
signals into electrical information.
Air curtains (a flow of purge air) prevent soot from
depositing itself on the optical windows.
The measuring chamber is equipped with a heater to
prevent water condensing on the walls of the chamber
and to keep the temperature of the exhaust gas above
dew point.
Zero position compensation takes place automatically.
3.7.4

Correct operation

To ensure correct operation, the temperature of the
exhaust gas and the measuring chamber is continually
monitored.
In addition, zero position compensation takes place
before each measuring cycle. This incorporates a
check of the degree of contamination of the optical
measuring path.
If one of the above parameters is outside the permit-
ted tolerance, measurement is not possible.
Robert Bosch GmbH