Leds - Bosch Rexroth PRC7000 MGDM Betriebsanleitung

108/118 Bosch Rexroth AG | Electric Drives and Controls

16 LEDs

Features:
At the front part of the MGDM are arranged 7 Diagnosis LEDs.
LED „ US1" supply voltage 1
Tab. 8:
State Meaning
dark No supply voltage
green Supply voltage US1 available
LED „ US2" supply voltage 2
Tab. 9:
State Meaning
dark No supply voltage
green Supply voltage US2 available
Tab. 10: LED „ PWR" Status internal power supply
State Meaning
dark No internal power supply
yellow Internal power supply available, configuration start
green Internal power supply available
Tab. 11: LED „ MS" Modul Status
State Meaning
dark Module not in operation
red Hardware fault, switch module off and on again
yellow Not used
flashing yellow Not used
green Module state ok
flashing green Not used
Tab. 12: LED „ S" Sercos Status
State Meaning
dark no Sercos communication
orange Sercos communication phase 0 is active
flashing green once,
Sercos communication phase 1 is active
then orange
flashing green 2 Sercos communication phase 2 is active
times, then orange
flashing green 3
Sercos communication phase 3 is active
times, then orange
green permanent Sercos communication phase 4 is active
flashing yellow then Device is in hot plug phase 0
green intermittently
flashing once Device is in hot plug phase 1
orange then green
R911381901 | Rexroth PRC7000 MGDM