Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
R911332355 | PSI 6xxx.757
10.1.5 Updates from Firmware Version AJ -110
Cyclic memory tests
o
10.1.6 Updates from Firmware Version AK -112
• Troubleshooting (driver error after switching on the fan)
• Force stepper for tip dress programs
• The fan can be switched off in a run-free time
• End of stepper and error message if twice the maximum wear is exceeded
• Serial Output O26 "Current sensor error" is not set if a current time is less than
the fade-out time and therefore no current can be measured
• Adjustment of the default parameters
Program 99 serves as pure deletion program for all electrodes 1-9, electrode
assignment = 0
Stepper of electrodes 2-9 to OFF
Phase angle for current scaling to 10 and 30
Current monitoring 2nd current band programs 1-255
SP_UPPER_TOL_BAND_2_Weld =
o
SP_LOWER_TOL_BAND_2_Weld = 5%
o
SP_COND_TOL_BAND_2_Weld =
o
Service programs are assigned to electrodes (assignment takes place from
electrode 1-5)
Electrode 1 = 1,11,21,31,41,51,61,71,91(special case RZ-
o
Handshake)
Electrode 2 = 2,12,22,32,42,52,62,72
o
Electrodes 3-5 proportionate
o
10.1.7 Update from Firmware-Version –AL -113
• Troubleshooting Timeout communication channels for Anybus CC modules
Bosch Rexroth AG
47/48
10%
3%
Werbung
Kapitel
Inhaltsverzeichnis
