Mounting Accessories - Parkside PRS-710 Bedienungs- Und Sicherheitshinweise

5) Service
a. Please use a qualified expert who
uses original replacement parts to
repair your power tool. This will ensure
proper functioning of the power tool.
The machine must not be damp and must
not be operated in a wet environment.
Wear protective gloves and sturdy
footwear.
Hold power tool by insulated gripping
surfaces, when performing an
operation where the cutting accessory
may contact hidden wiring or its own
cord.
Cutting accessory contacting a "live"
wire may make exposed metal parts of
the power tool "live" and could give the
operator an electric shock.
Do not saw materials containing
asbestos!!!
• Wear protective goggles when working
with materials which produce large
amounts of chips.
• Wear a protective mask when sawing
other fibrous materials.
• Remove adjusting keys and wrenches
before turning the tool on.
• Secure your workpiece with clamps.
• Move machine towards the workpiece
only when switched on.
• Always hold machine with both hands
and ensure that you have a safe
footing while working.
• The machine may be operated only
with the foot plate mounted. When
sawing, the foot plate must always rest
on the workpiece.
• Incorrect handling may damage the
machine. Therefore always comply
with the following instructions.
RSM6026 Lidl Manaul E # 0812-22 FC.indd 29
Safety instructions / Mounting accessories
• Use only sharp saw blades in perfect
condition; replace cracked, distorted or
blunt saw blades immediately.
• Machine should only be switched on
with blade installed
• Select tools, stroke rate and pendulum
actions according to material, Take
care to maintain a constant reed rate.
• Do not attempt to stop the saw blade
with lateral pressure after switching off.
• Only use genuine accessories.

3. MOUNTING ACCESSORIES

Fitting a saw blade
Fig. B
The machine is equipped with a quick fit
system.
• Turn the clamping ring (2) of the
saw blade holder as far to the left as
possible and hold it there.
• Place the saw blade in the blade
holder.
• Let go of the clamping ring.
• Make sure when changing the saw
blade that the blade holder is free of
material debris (such as splinters of
wood or metal).
• Before use, always check that the saw
blade is securely fixed.
Removing the saw blade
• Turn the clamping ring (2) of the
saw blade holder as far to the left as
possible and hold it there.
• Remove the saw blade from its holder.
• Let go of the clamping ring.
Adjusting the foot plate position
When the blade loses its sharpness
at some sections of it's cutting edge,
reposition the foot plate (1) to use a sharp,
unused portion of its cutting edge.
GB/MT 29
12/22/08 1:42:09 PM