Installing The Dust Extraction System; Mounting The Adapter For External Extraction; Adjusting The Additional Handle; Working Procedures - Parkside PWBS 180 B2 Originalbetriebsanleitung

Installing the dust extraction system

Dust from materials such as lead-based paints,
some types of wood, minerals and metal can be
harmful to health. Touching or inhaling the dusts
may cause allergic reactions and/or respiratory
illnesses of the user or people in the vicinity.
Certain dusts such as oak or beech dust are consid-
ered carcinogenic, especially in combination with
wood treatment additives (chromate, wood preserv-
atives). Materials containing asbestos may only be
worked on by specialists.
■ Always use dust extraction.
■ Operate the power tool either with the dust
bag or connect an approved dust and chip
extraction device.
■ Ensure that your workplace is adequately
ventilated.
■ We recommend you wear a respirator with
a class P2 filter.
■ Avoid kinking the suction hose
Observe the applicable regulations in your country
regarding the materials to be worked.
♦ Plug the inlet side of the suction hose
the extraction nozzle
♦ Pull the mouthpiece
Open the zip on the dust bag
the outlet end of the suction hose
corresponding opening on the dust bag
Reconnect the mouthpiece
hose from the inside. Close the zip on the
dust bag .
18a
♦ Proceed in the reverse order to dismantle the
suction hose .
│ GB │ MT
■ 42
.
onto
.
off the suction hose
19a
. Now plug
18a
into the
.
to the suction
19a
Mounting the adapter for external
extraction
♦ Push the dust extraction adapter
extraction nozzle
♦ Connect an approved dust extraction system.
NOTE
► When sawing wood or other materials that
can create dusts that are hazardous to
health, always connect a suitable, certified
vacuum extractor appliance.

Adjusting the additional handle

The angle of the additional handle
adjusted to achieve a more favourable working
position for the guide hand in certain applications
(e.g. when grinding close to an edge).
♦ Loosen the two wing screws
additional handle
position.
♦ Retighten the wing screws

Working procedures

WARNING! RISK OF INJURY!
.
► Always remove the plug from the power
socket before working on the appliance.
► Wait until the appliance has come to a
standstill before putting it down.
The removal rate and the surface quality are deter-
mined by the selection of the sanding tool, the
preselected speed level and the contact pressure.
Only sanding tools that are in perfect condition
provide a good sanding performance and protect
the appliance.
onto the
.
can be
and tilt the
to the desired working
.
PWBS 180 B2