Troubleshooting - Bosch MFW39 Gebrauchsanleitung

Troubleshooting

Problem
The appliance does not
start when switched on.
The appliance is running
normally, but the food is
not being processed.
The food is not being
processed or only very
slowly.
The reversing function
does not start.
If you are unable to solve the problem, always call the hotline!
You will find the telephone numbers at the back of these instructions.
Cause
Appliance has no power
supply.
The appliance was
overloaded, and
the agitator paddle
has broken at the
predetermined breaking
point.
The attachment or worm
gear is blocked.
The pressure on the
pusher is too great or the
feed chute is too full.
The food to be processed
still contains hard
components.
Button + was
pressed too briefly.
The worm gear is
blocked right up.
Troubleshooting
Remedy
Insert the mains plug in the socket.
Switch the appliance off and wait
until it has stopped. Unplug the
appliance, remove the attachment,
take it apart and clean. Replace
the agitator paddle. X "Overload
protection" see page 22
Appliance without reversing
function: Switch appliance off,
wait until it has stopped and
unplug. Remove the attachment,
take it apart and clean to eliminate
the blockage. X "Care and daily
cleaning" see page 27
Appliances with reversing
function: Switch off the appliance
with button k and wait for the
drive to come to a standstill. Press
and hold button +. After
approx. 5-10 seconds, release
button + and wait for the
drive to come to a standstill.
Switch the appliance on again and
continue to use it. X "Reversing
function" see page 22
Reduce the pressure on the
pusher and fill the feed chute with
less food.
Remove hard components.
Precook/steam vegetables before
processing them.
Press and hold button +
until the reversing function starts.
Switch the appliance off, wait
until it has stopped and unplug.
Remove the attachment, take it
apart and clean to eliminate the
blockage. X "Care and daily
cleaning" see page 27
en
31