Citrus Press Attachment; Grain Mill Attachment - Bosch MFW39 Gebrauchsanleitung

Citrus press attachment

For squeezing juice out of citrus fruits,
e.g. lemons, oranges, grapefruits.
Preparation
W Risk of injury!
The attachment for the citrus press is
directly assembled on the base unit. Do not
insert the mains plug until all preparations
for working with the appliance are complete.
Caution!
The base unit is moved through 90° for
preparation and use of the citrus press
attachment. Never use other attachments in
this position.
X Fig. I
1. Hold the base unit by the carrying
handle and carefully tip up so the
drive points upwards. Possibly turn the
base unit to make the buttons easily
accessible.
2. Insert the driving shaft with the spring
element pointing down in the drive of the
base unit.
Caution!
It should be possible to push the driving
shaft down lightly with your finger. It must
not get sticky with residue from juice or
become blocked with pips or foreign bodies.
3. Fit the collecting tray onto the drive at an
angle.
4. Turn the collecting tray anticlockwise until
you hear it click into position.
5. Fit the filter insert onto the collecting tray.
6. Fit the pressing cone onto the driving
shaft.
The citrus press attachment is now fitted to
the base unit and prepared.
Use
X Fig. J
1. Cut the citrus fruits in half.
2. Place a suitable container under the
attachment.
3. Connect the mains plug. Switch on the
appliance. The drive is running.
Citrus press attachment
Caution! (MFW3X...)
After switching on, the appliance runs at
speed 2 (fast). To use the citrus press, you
must press button + once to switch
to speed 1 (slow). X "Speed setting" see
page 22
4. Position the halved citrus fruits with
the cut surface on the pressing cone
and press down. As soon as the fruit
is pressed onto the pressing cone, the
cone will rotate.
5. To finish the process, reduce the
pressure on the cone.
6. Once you have finished, switch off the
appliance and pull out the mains plug.
7. Hold down the release button and
turn the attachment clockwise until it
disengages.
8. Remove the attachment, take it apart
and clean all parts. X "Care and daily
cleaning" see page 27
Notes:
– To obtain the largest amount of juice,
the pressing procedure should be
repeated a few times.
– The filter insert with the pulp and pips
should be emptied as necessary.

Grain mill attachment

For grinding products such as wheat,
oats, rice, coffee beans, peppercorns,
wild mustard, walnuts, hazel nuts, dried
mushrooms, almonds, soya, linseeds,
buckwheat groats, shelled sunflower seeds,
etc. The appliance is not intended to be
used for grinding very hard products such
as dried peas, maize or popcorn. X "Tips"
see page 28
Preparation
X Fig. K
1. Place the adjustment screw in the
setting ring. Ensure that the scale points
upwards.
2. Press the adjustment screw towards the
grinding chamber and turn the setting
ring in a clockwise direction until the
scale for the grinding level is reached.
en
25