techem Typ 4.1.1 Betriebsanleitung Seite 20

3 Service level
S0
Info
S1
Radio on / off
(only for devices with radio)
S2 M-Bus primary address
(only for devices with M-Bus)
S3
Max. value output
S4
Future due date
S5
Serial number
S6 (1)
Firmware version calibration-relevant part
S6 (2) Firmware version not a calibration-relevant
part
S6 (3)
Firmware version Techem
S6 (4)
Firmware check sum calibration-relevant
part
* Before the first due date: Production date or optional starting date
** Option only without Techem readout and billing service
*** Depending on existing parametrisation
KT = short button press < 2s
LT = long button press > 2s
3T = button press ≈ 3s
Parametrisation level - for setting the variable device properties
To parametrise the desired energy unit or installation location, proceed as follows:
Change to the ribbon "Parametrisation level" (C0 - Config)
1
2 Press the button briefly so long until the desired parameter appears.
3 Then, press the button (approx. 3s) until the display changes to "SEt" .
4 The desired parameter is set.
Please note:
If the button is not activated, the display jumps back to "C0 - Config" .
Restriction of parametrisation, see Chapter "Device properties".
20
4 Metrological log
L0
Log
L1 (1)
Date***
L1 (2) Decimal place***
L2 (1)
Date***
L2 (2)
Unit - MWh***
L3 (1)
Date***
L3 (2)
Decimal place***
L4 (1)
Date***
L4 (2)
Unit - kWh***
L5 (1)
Date***
L5 (2)
Decimal place***