Device Use - I-Tech MIO-SONIC Benutzerhandbuch

the environmental electrical installation to which MIO-SONIC is
•
connected is compliant to the national laws;
the instructions for use contained in this manual are strictly
•
followed.
Should any foreign materials penetrate the device contact the retailer or
manufacturer immediately. If dropped down, check that the housing is not
cracked or damaged in any way; if so, contact the retailer or manufacturer.
Should you notice any changes in the device's performance during treatment,
interrupt the treatment immediately and consult the retailer or
manufacturer.
Consult
osteosynthesis devices.
IF YOU HAVE ANY DOUBTS REGARDING THE DEVICE USE CONSULT YOUR
DOCTOR.

Device use

Clean and disinfect the ultrasound head with a disinfectant solution before
and after the use.
To utilize MIO-SONIC:
1. connect the power supply to the device.
2. Move the switch to the ON position: the power
indicator (under the written POWER) will
illuminate, while the other six will begin to light
up alternatively and the head will start to
vibrate reporting
automatically preheating mode. When the
preset temperature is reached (after about 3
minutes) the six lights will flash 5 times, so the
IACER Srl
a doctor before
that
using MIO-SONIC
the device has
38
with metallic
MNPG71-04