Disposal - Kessel EasyClean free Einbau- Und Betriebsanleitung

6

Disposal

Carry out disposal
Partial emptying
Connect the suction hose of the disposal vehicle to the
Storz-B coupling.
Turn the control valve to the DRAIN position (arrow to the
right).
Start manual operation at the control unit.
Wait until 1/3 of the static level has been pumped off.
How long this takes depends on the nominal size.
Pause manual operation at the control unit.
Mix
Turn the control valve to the RINSE position (arrow to the
left).
Start manual operation at the control unit.
Wait until the separator content has been homogenised
sufficiently. How long this takes depends on the nominal
size. The times in the table shown below can be taken as
reference values.
Pause manual operation at the control unit.
Pump off
Turn the control valve to the DRAIN position (arrow to the
right).
Start manual operation at the control unit.
Wait until the pump stops running.
End the pumping process at the disposal vehicle.
Nominal size of Duration of the mixing process (in
the separator seconds)
NS 2 140
NS 4 225
NS 7 345
NS 10 450
Refilling the tank
Open the cold water valve.
Wait until the water level has reached the static level
stop cold water supply.
Place the control valve in the RINSE position (arrow to
the left). This is the lever position for normal opera-
tion.
Disconnect the suction hose of the disposal vehicle from
the Storz-B coupling.
Record the disposal in the log book.
✓ Disposal procedure is completed.
28 / 112
,
016-189_01