Installation - Grundig GIEH 823470 Handbuch

Installation

The electrical and mechanical in-
stallation must be performed by
qualified personnel.
The electrical appliance is designed
to be built-in to a 2-6 cm thick work-
top in the case of TOP installations;
2.5-6 cm in the case of FLUSH in-
stallations.
The minimum clearance between
the cooktop and wall must be at
least 5 cm at the front, at least 4 cm
on the side and at least 50 cm with
respect to the wall units above.
Note: The suggested clearances
are indicative: when designing the
spaces, follow the instructions of
the kitchen manufacturer.
3.1 Electrical connection
• Disconnect the device from the
electrical network
• The installation must be per-
formed by professionally quali-
fied personnel familiar with the
applicable installation and safety
standards.
• The manufacturer declines any
liability to people, animals or
things in the case of failure to fol-
low the guidelines provided in this
chapter.
• The power cable must be long
enough to allow removal of the
hob from the worktop.
• Make sure that the voltage on the
rating plate on the bottom of the
device corresponds to that of the
house where it will be installed.
• Do not use extension cords.
• Earthing is required by law
• The earth power cable must be
2cm longer than the other cables
• If the household appliance is not
equipped with a power cable, use
one with a minimum conductor
diameter of 2.5 mm2 for power
up to 7200 Watt; for higher power
levels, the diameter must be 4
mm2.
• At no point along the length of the
cable must it reach a temperature
of 50° C above the room tempera-
ture.
• The device is intended to be per-
manently connected to the elec-
trical network, therefore, make
the connection to the fixed net-
work via a standard omnipolar
switch, which assures the com-
plete disconnection of the mains
under category III overvoltage
conditions, and which is readily
accessible after the installation.
ENG
DE
DA
NO
SV
FI
PL
CS
SK
IT
RO
NL
FR
59