Grundig GIEH 823470 Handbuch Seite 57

Installation
Note: To connect the appliance us-
ing the optional single phase or
three-phase connection, the exist-
ing cable must be removed and re-
placed with another type (not sup-
plied) having the following specifi-
cations: single phase connection:
H05V2V2-F 3G4 cable three-phase
connection: H05V2V2-F 5G2.5 cable
Caution! Before reconnecting the
circuit to the mains power supply
and checking its correct operation,
always check that the network ca-
ble has been correctly assembled.
Caution! The interconnection ca-
ble must be replaced by author-
ised customer service personnel or
equally qualified person.
3.2 Mounting
Before starting the installation:
• After unpacking the product,
check that it has not been dam-
aged during transport and in the
case of problems, contact your
dealer or Customer Service, be-
fore proceeding with the installa-
tion.
• Check that the product is the right
size for the installatio location.
60
• Check for accessories inside the
packaging (placed there for ease
of transport) such as bags con-
taining screws, the warranty card,
etc.. Remove them and keep them
safe.
• Also check that there is a power
socket near the installation area
Preparing the cabinet for installa-
tion:
• The product cannot be installed
above cooling appliances, dish-
washers, heaters, ovens, washing
machines and dryers.
• Cut the cabinet before insert-
ing the hob and carefully remove
shavings or sawdust.
Important: use a single compo-
nent adhesive sealant (S), resistant
against high temperatures up to
250°; prior to installation, the sur-
faces that need to be glued must
be carefully cleaned, removing all
substances that may compromise
adhesion (e.g. release agents, pre-
servatives, grease, oils, powders,
old adhesive residue, etc.); the
sealant must be evenly distributed
along the entire perimeter of the
frame; after gluing, leave to dry for
approximately 24 hours.
Fig. 1b