Teufel WJT 8 Gebrauchsanweisung Seite 27

Place the dummy lock body
on the model and check its
position again. The position
of the dummy will later define
the orientation of the pin in
the socket. (Fig. 4)
4
If the dummy version used
has a threaded hole, use Mo-
delsil Silicone Modelling Putty
(REF 72.000.821.03) to seal
the hole. (Fig. 5)
5
WJT 8 Lock System
Remove the mounting plate
from the lock body. Screw
the dummy hex screw far
enough into the dummy so it
is flush with the surface of the
dummy body. (Fig. 6, 7, 8)
6
7
8
ES
FR
User Manual EN
DE
D D
EN-9