Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ES
FR
EN
WJT 8 Lock System
D D
DE
Application/
Adjustment
We recommend executing
the following steps of the
application process in the
order suggested below.
Assembly
We recommend to not directly
laminate the lock into the socket,
but to rather use the mounting
plate. In this case, a separately
available dummy kit has to be
used during installation.
Clamp the model into a vacu-
um tube. Drill a vertical hole to
accommodate the dummy lock
body. Drill diameter: 7.5 mm.
(Fig. 1)
1
EN-8
User Manual
surface for the dummy on the
distal end of the residual limb, at
a right angle to the axis of the
limb. The angle of the flattened
area will later determine the
orientation of the pin. (Fig. 2)
2
Pull a thin stockinette over the
model (we recommend using
Feather Stretch material, REF
PA.0013x00), tie it off at the
distal and the proximal end.
Insert the knot into the drill hole
on the distal end. (Fig. 3)
3
Centrically flatten the
Werbung
Inhaltsverzeichnis
