Setting The E.box With Dip Switches; Activation Of The Set; Figure 39: System Status In Configurations: A With Only Depth Sensor, B: Depth Sensor And Floats, C Depth Sensor And Level Probes; Figure 40: Setting The Drainage Dip Switches - DAB E.Box Plus Installations- Und Wartungsanleitungen

In point 7 it is possible to choose the type of signal that will generate the maximum and minimum level alarms. Floats, level probes or the data
provided by the depth sensor may be used. If the depth sensor is used, the maximum ML and the minimum LL level alarm thresholds must be set
in accordance with Figure 43. The installation sequence with only the depth sensor is shown.
System status and starting

Figure 39: System status in configurations: A with only depth sensor, B: depth sensor and floats, C depth sensor and level probes

7.10

Setting the E.box with dip switches

If the E.box is provided with a display, it is recommended to use the display for configuration. Otherwise it is possible to use the dip switches inside
the panel and set them as shown in Figure 40 Setting dip switches for drainage.
7.11

Activation of the set

To activate the set it is necessary to enable the pumps. During the first configuration, for safety's sake, the pumps are disabled and
are OFF. To change to automatic mode, just briefly press the
The following modifications may be made during configuration:
If you want the pumps to be exchanged every 24 hours and not at each restart, set DS_A2 at ON.
•
If you do not want protection against too rapid restarts, set DS_A3 at OFF.
•
If you do not want to use the pump P1 set DS_A7 at ON.
•
If you do not want to use the pump P2 set DS_A8 at ON.
•
ENGLISH

Figure 40: Setting the Drainage dip switches

Figure 41: Enabling P1 and P2.

93
buttons on the pumps P1 and P2. As shown in Figure 41.