Configuration With Pressure Switches; Setting The E.box With Dip Switches; Figure 13: Configuration With Pressure Switches; Figure 14: Dip Switches For Pressure Boosting - DAB E.Box Plus Installations- Und Wartungsanleitungen

5.10

Configuration with pressure switches

5.11

Setting the E.box with dip switches

If the E.box is provided with a display, it is recommended to use the display for configuration. Otherwise it is possible to use the dip switches inside
the panel and set them as shown in Figure 14 Dip switches for pressure boosting.
The following modifications may be made during configuration:
If the expansion vessel is larger than 100 litres, set DS_A1 at OFF.
•
If you want the pumps to be exchanged every 24 hours and not at each restart, set DS_A2 at ON.
•
If you do not want protection against too rapid restarts, set DS_A3 at OFF.
•
If you do not want protection against lack of water, set DS_A4 at OFF.
•
If you do not want to use the pump P1 set DS_A7 at ON.
•
If you do not want to use the pump P2 set DS_A8 at ON.
•
If you intend to use a set-point between 7 and 16 bar, set DS_B5 at ON.
•
If you intend to use pressure switches, set DS_B7 at OFF.
•
ENGLISH

Figure 13: Configuration with pressure switches

Figure 14: Dip switches for pressure boosting

77