Mounting The Bicycle Rack - Eufab AMBER 3 Bedienungsanleitung

Personal injury or property damage due to loss of the bicycle rack
while driving.
A loose or faulty connection between the bicycle rack and trailer tow bar can
lead to the detachment of the bicycle rack.
• Replace a defective trailer tow bar.
• Clean the trailer tow bar of dirt, dust and grease.
Personal injury or property damages caused by increased wind loads
The bicycle rack and trailer tow bar may be damaged by too high a wind load.
• Remove all bags from the bicycle before starting your journey.
• Do not use protective covers for the bicycle during the journey.
The general operating permit must be carried in the
vehicle when the rack is mounted.
Do not travel with the bicycle rack empty. Store it in
the boot of your vehicle. This prevents increased fuel
consumption and protects the rack.
The driver is always responsible for ensuring that the
load and the load securing meet the regulations.

6. MOUNTING THE BICYCLE RACK

The bicycle rack must first be assembled. Take all of the components out of the
packaging and set them out clearly. Every stage is described and clearly shows
which components are required for the assembly of the rack.
Step 1
Components
Assembly
Two wheel rails form a pair. Place three pairs of wheel rails, with the plastic
shells on the outside, so that they are parallel on the base frame and the
drilled holes in the rail match the holes in the base frame. Secure each wheel
rail to the base frame with the lock screws M6 x 50, washers and self-tapping
nuts M6.
Join the two halves of the lamp mount set together. This is made easier by
the small guide element which is already mounted on one side. Push the rails
together and secure the connection with the cross-headed screw (M5x12),
spring washer and washer.
Insert the cross-headed screws M5 x 35 with spring washers and washers,
from below, through the vertical drilled holes of the lamp mount. Insert the
screws through the threaded holes on the underside at the end of the lamp
mount. Tighten the screws.
Make sure that the fog light is installed on the left side of the mount!
Step 2
Components
Assembly
Place the U-bracket on the U-bracket mount of the base frame. Secure the
U-bracket with the supplied lock screws (M8 x 60), washers and knob nuts
M8. The knob nuts must be mounted on the inside (see photograph).
9