Eufab AMBER 3 Bedienungsanleitung Seite 10

Caution: You must tighten both knob nuts very firmly to ensure that the
U-bracket is flush against the U-bracket mount.
Step 3
Components
Mounting the frame holder
Undo the handle screw of the frame holder and rotate out fully. Open the cuff
of the frame holder and place the inserts around the U-bracket at a position
suitable for your bicycle. Place the cuff around the inserts and push firmly
together. Close the frame holder using the handle screw (but do not tighten).
Mounting the license plate holder
Remove the screws from the lamp mount before installing the license plate
holder and then mount the license plate holder.
The license plate holder must be at the same height as the lights.
Inserting the license plate
The mounting clips for securing the license plate are push-out parts in the
holder. Break out two of the clips. Slide the license plate into the holder, then
push the clips into the cut-outs to secure the license plate.
Clips
Cut-outs
Laying electrical cables
Secure the cables of the lights to the underside of the rack using the supplied
cable ties. Make sure that the cables cannot be damaged when lowering and
raising the rack.
10
Cut-outs
Mounting the short tensioning straps
Insert the short tensioning strap from the inside to the outside below the bike
holder and then from the outside to the inside through the slots of the bike
holder (see photograph).
Attaching the plastic covers
Fit the plastic covers onto the middle of the wheel rails.
Mounting the bicycle rack on the trailer tow bar
Before you put the bicycle rack on the trailer tow bar, familiarise yourself with
the quick locking system.
Set bolt Safety pin
Set bolt
Ensure that the trailer tow bar is undamaged, clean and free of grease.
The quick locking mechanism is a component with a lever. Activating the lever
opens or closes the quick locking mechanism. With the help of the securing
bolt and the padlock, the quick locking system may be locked and secured.
The padlock must always be used as additional security
when using the bicycle rack.
Park your vehicle on a level surface.
Switch the motor off and pull on the brake.
Remove the securing bolt from the quick locking mechanism and rotate by
90° to prevent it from engaging again. Open the quick locking mechanism by
lifting the lever.
Place the rack, from above, horizontally onto the trailer tow bar. Push the
lever of the quick locking mechanism down (force required is approximately
35 - 40kg) as far as it will go (the lever will remain in the horizontal position).
Check whether the bike rack is securely and firmly positioned on the trailer
tow bar and can no longer be rotated. If this is not the case, the quick locking
mechanism must be readjusted. Lift the lever and remove the rack from
Lever
Lock
Lock nut