Overview; Setting Up The Bicycle Assembly Rack - Eufab 16421 Bedienungsanleitung

recommended by the manufacturer!
• Always set the bicycle assembly rack up on a firm, even and flat surface. There is a risk of tipping and injuries.
• Never load the bicycle assembly rack with more than 30 kg. There is a risk of injuries or damage to objects.
• Prior to each use, check the bicycle assembly rack for damages, such as cracks or deformation. A damaged
assembly rack may not be used.
• Never sit on a bicycle that is clamped into an assembly rack.
• When clamping the bicycle frame into place, pay attention to ensure that none of the cords or electrical
lines are damaged.
• When clamping the bicycle frame, pay attention to ensure that delicate bicycles frames, such as those made
from carbon or thin-walled aluminium, are not damaged.
• If possible, always clamp the bicycle frame via its centre of gravity. There is a risk of tipping and injuries.
5. OPERATING INSTRUCTIONS

5.1 OVERVIEW

1 Base foot
2 Quick clamping base foot
3 Quick clamping telescopic pipe
4 Tool shelf
5 Upper telescopic pipe
6 Handlebar bracket
7 Frame clamps
8 Quick closure frame clamps
9 Locking mechanism for folding joint
10 Unlocking mechanism for
rotating mechanism
11 Locking lever for rotating mechanism
The bicycle assembly rack is, for the most part, already pre-assembled. You only need to mount the tool shelf and handlebar
bracket.

5.2 SETTING UP THE BICYCLE ASSEMBLY RACK

Fold the base foot out (Position 1 in the Overview). Secure the base foot in position using the quick clamp (Position 2 in the
Overview). To do this, fold the lever of the quick clamp up to the pipe. If this is not secure enough, fold the lever back and ro-
tate it clockwise 1 or 2 turns on the thread. Then fold the lever of the quick clamp back up to the pipe. Repeat this procedure
until the base foot is sufficiently secured.
Pull the upper telescopic pipe out (Position 5 in the Overview). Secure the telescopic pipe with the quick clamp (Position 3
in the Overview) by folding the lever up to the pipe. If this is not secure enough, fold the lever back and rotate it clockwise
1 or 2 turns on the thread. Then fold the lever of the quick clamp back up to the pipe. Repeat this procedure until the upper
telescopic pipe is sufficiently secured.
Fold the head, with the frame clamp (Position 7 in the Overview) into the working position,
Figure 2. Secure the head by pushing the lever of the locking mechanism into place (Position
9 in the Overview). If this is not secure enough, fold the lever back and rotate it clockwise 1
or 2 turns on the thread. Then fold the lever back up to the pipe. Repeat this procedure until
the head is sufficiently secured with the frame clamp.
Fit the tool shelf (Position 4 in the Overview) into the bracket on the lower telescopic pipe.
6
Figure 2