Mounting The Plastic Cover; Mounting The Bicycle Rack On The Trailer Tow Bar; Mounting The Bicycle To The Bicycle Rack - Eufab AMBER 1 Bedienungsanleitung

6.1.8 MOUNTING THE PLASTIC COVER

Fit the plastic covers onto the middle of the wheel rail.
Result of Step 3

6.2 MOUNTING THE BICYCLE RACK ON THE TRAILER TOW BAR

Before you put the bicycle rack on the trailer tow bar, familiarise yourself
with the quick locking system.
Set bolt Safety pin
Set bolt
Ensure that the trailer tow bar is undamaged, clean
and free of grease.
Remove the paint from the ball head of the trailer tow
bar
The quick locking mechanism is a component with a lever. Activating the
lever opens or closes the quick locking mechanism. With the help of the
securing bolt and the padlock, the quick locking system may be locked and
secured.
The padlock must always be used as additional security
when using the bicycle rack.
Park your vehicle on a level surface.
Switch the motor o and pull on the brake.
Remove the securing bolt from the quick locking mechanism and rotate by
10
Lever
Lock
Lock nut
90° to prevent it from engaging again. Open the quick locking mechanism
by lifting the lever.
Place the rack, from above, horizontally onto the trailer tow bar. Push
the lever of the quick locking mechanism down (force required is
approximately 35 - 40 kg) as far as it will go (the lever will remain in the
horizontal position).
Check whether the bike rack is securely and rmly positioned on the
trailer tow bar and can no longer be rotated. If this is not the case, the quick
locking mechanism must be readjusted. Lift the lever and remove the rack
from the trailer tow bar. Undo the lock nut of the adjusting screw and rotate
the adjusting screw on the quick locking mechanism tighter by a quarter
turn. Then tighten the lock nut again.
Replace the rack back on the trailer tow bar and check whether the rack
is securely and rmly positioned on the tow bar. Repeat the adjustment
process until the rack is secure and rm.
CAUTION
Always make sure that the lock nut of the adjusting
screw is correctly tightened!
Slight signs of pressure on the tow bar ball are normal
and do not in uence the functionality.
When the rack is rmly seated on the trailer tow bar, rotate the securing
bolt of the quick locking mechanism until it engages. Now close the quick
locking mechanism with the supplied padlock and remove the key from
the lock. Store the key carefully and in a safe place. The bicycle rack is now
secured to prevent theft.
Regularly check the rm seating of the rack on the trailer tow bar as well as
the attachment of the bicycle to the rack. Also regularly check the functions
of the lighting system of your bicycle rack.

6.3 MOUNTING THE BICYCLE TO THE BICYCLE RACK

Since the frame holders are not tied to any speci c position, you may try
out a number of positions. It is important to ensure that the frame holder is
tted as high as possible.
Place the bicycle in the wheel rail. Connect the frame of the bicycle to the
U-tube using the frame holder.
Secure the wheels with the supplied short tensioning straps. Use one
tensioning strap to secure the rear wheel and two for the front wheel (see
picture) to prevent them from turning.