Wintering Procedure - Teuco P013A Serie Gebrauchsanweisung

EN

wINTERING pROCEDURE

Empty the minipool completely, as follows:
1 - isolate the minipool from the power supply at the control
panel .
2 - Open the outlet discharge valve/s on the
hydromassage pump/s (if the pump/s is/are not
equipped with an outlet discharge valve partially
unscrew the ring), the compensation tank, the
connecting tubing between the mini-pool and the Spa-
pack and the D60 tubing to the mini-pool (if present) .
3 - drain the water from the filter pump by undoing the
plug at the bottom of the prefilter basket .
4 - remove water lying on the bottom of the pool, using
a wet vacuum cleaner .
5 - cover the minipool with the canvas provided, so that
it will not collect dirt .
before using the Teuco mini-pool again after the
winter period, proceed as described in FIRST START-
Up.
If the pool is to be used during winter, it will be good
policy to lag the overflow tank and all pipelines with
suitable insulation.
SAND FILTER
Empty the filter of water by removing the external drain
plug . This will ensure that water only runs off, and not the
sand, which is retained by the drain outlet filter .
CARTRIDGE FILTER
Empty the filter of water by removing the external drain
plug (5) .
The cartridge must be removed from the housing,
cleaned, and stored in a dry place .
26
1
2
3