Teuco P013A Serie Gebrauchsanweisung Seite 29

8 - pOwERING Up ThE SySTEM
EN
Set the filter pump switch to "STOP" .
Power up the control panel by setting the main switch to
"ON" .
The filler solenoid valve will cut in automatically to bring
the water up to operating level in the overflow tank.
Set the filter selector valve to "3" (RINSE) .
Set the pump switch to "MAN" (manual) .
Water will now flow from the overflow tank into the filter,
washing the sand, and from the filter directly to the drain.
After 30-40 seconds operation, shut off the rinse flow by
setting the pump switch to "STOP" .
9 - Shift the selector lever to position "1" (FILTER) .
Set the pump switch to "MAN" (manual) .
Water will begin flowing from the pool through the filter.
29