Teuco P013A Serie Gebrauchsanweisung Seite 28

EN
4 - FILLING ThE MINIpOOL
Fill the pool until the water is up to the rim .
5 - FILLING ThE SAND FILTER
a - Remove the cap of the sand filter
by undoing the nuts and washers .
b - Place a bag over the pipe inside
the filter, for protection .
c - Pour 45 litres of water into the
container and, slowly, add 6 bags of
sand (supplied with the pool), making
certain not to damage the inside of
the filter .
CAUTION: DO NOT INhALE ThE
DUST.
Having completed the above steps,
remove the protective bag and clean
the rim of the filter .
Refit the cap of the filter, greasing
the seal with vaseline .
Tighten the nuts and washers
uniformly, wIThOUT FORCING .
6 - Continue filling the pool, allowing the water to spill
over the edge and away to the overflow tank .
Stop filling the pool when the water reaches the
level of the first metal reinforcing hoop.
7 - Open all valves along the pipelines, except for the
system drain valve, and check that there are no leaks
from pipes or fittings .
26
a
b
c
a
b
c
45 lt.
x6