Herunterladen Inhalt Inhalt Diese Seite drucken

Stihl RMI 632 Gebrauchsanleitung Seite 180

Vorschau ausblenden Andere Handbücher für RMI 632:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
– Check perimeter wire – ensure correct
routing in the area of the docking station
(
9.9)
Message:
2000 – Signal problem
Dock iMOW®
Possible cause:
– Wire signal faulty, fine tuning necessary
Remedy:
– Place the robotic mower in the docking
station – then press OK
Message:
2020 – Recommendation
Annual service by spec. dealer required
Possible cause:
– Machine service recommended
Remedy:
– Have the annual service carried out by
a STIHL specialist dealer
Message:
2030 – Battery
Allowed operating time reached
Possible cause:
– Battery replacement necessary
Remedy:
– Have the battery replaced by a STIHL
specialist dealer
178
Message:
2031 – Charging failure
Check charging contacts
Possible cause:
– Charging cannot be started
Remedy:
– Check the charging contacts on the
docking station and robotic mower and
clean if necessary – then confirm the
message with OK
Message:
2032 – Battery temperature
Outside temperature range
Possible cause:
– Temperature in battery during charging
too low or too high
Remedy:
– Allow the robotic mower to warm up or
cool down – observe permissible
temperature range of battery
Message:
2040 – Battery temperature
Outside temperature range
Possible cause:
– Temperature in battery when starting
mowing operation too low or too high
Remedy:
– Allow the robotic mower to warm up or
cool down – observe permissible
temperature range of battery (
Message:
2050 – Adapt mowing plan
Extend active times
Possible cause:
– Active times have been
shortened/deleted or the mowing
duration has been extended – the
stored active times are insufficient for
the necessary mowing operations.
Remedy:
– Extend the active times (
shorten the mowing duration (
Message:
2060 – Mowing completed
Press OK to release
Possible cause:
– Mowing in secondary area successfully
completed
Remedy:
– Return the robotic mower to the mowing
area and dock to charge the battery
(
15.7)
Message:
2070 – GPS signal
No reception at edge
Possible cause:
– The entire edge of the mowing area is in
a dead spot
Remedy:
6.4)
– Repeat edge following (
– Contact a STIHL specialist dealer for a
detailed diagnosis
11.7) or
11.7)
11.13)
0478 131 9954 A - EN

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Diese Anleitung auch für:

Rmi 632 pRmi 632 cRmi 632 pc

Inhaltsverzeichnis