Sharpening The Mowing Blade; Removing And Installing The Carrier Plate - Stihl RMI 632 Gebrauchsanleitung

Removing the blade:
Push in both tabs (1) on the
carrier plate with one hand and
hold. Remove the fastening
nut (2) with your other hand.
Remove the mowing blade together with
the fastening nut.
Installing the mowing blade:
Risk of injury!
Check the blade for damage before
installation. The blade must be
replaced if notches or cracks are
detected or if it is worn. (
The carrier plate and the
fastening nut must also be
replaced if damaged (e.g. broken,
worn). The fastening nut in
particular must engage cleanly in
the carrier plate.
● Clean the blade, carrier plate and
fastening nut prior to installation.
0478 131 9954 A - EN
Fit the mowing blade (1) on the carrier
plate (2) as illustrated. Ensure the correct
position of the retainers (3) in the mowing
blade.
16.3)
Screw on the fastening nut (1) as far as
possible. Several clicks are audible during
tightening. Ensure secure seating of the
mowing blade by shaking carefully.
● Following installation of a new mowing
blade, confirm the blade replacement in
the "More - Service" menu. (

16.5 Sharpening the mowing blade

Never re-sharpen blades.
STIHL recommends always replacing a
blunt blade with a new one.
Only new mowing blades are
balanced with the necessary
precision and guarantee proper
functioning of the machine as well
as low noise emissions.
16.6 Removing and installing the
carrier plate
The carrier plate can be removed in
order to clean the mowing deck.
● Activate the disabling
device ( 5.2) and wear
gloves.
● Tilt the robotic mower onto its
side and lean it securely against a
stable wall. Carefully clean the mowing
deck and mowing blade. (
Removing the carrier plate:
● Remove the mowing blade. (
11.16)
16.2)
16.4)
165