Starting Routing With An Internal Docking Station - Stihl RMI 632 Gebrauchsanleitung

Only use genuine fixing pins and
genuine perimeter wire. Installation
kits with the necessary installation
material are available as an
accessory from the STIHL
specialist dealer. (
Draw the wire routing in the garden sketch.
Content of the sketch:
– Contour of the mowing area including
important obstacles, borders and any
no-go areas which the robotic mower
must not mow. ( 12.1)
– Position of the docking station (
– Position of the perimeter wire
After a short while, the perimeter wire is
overgrown and is no longer visible.
Make a note of the routing of the wire
around obstacles in particular.
– Position of the wire connectors
After a short while, the wire connectors
used are no longer visible. Their
position should be noted in order to
replace them as required. (
The perimeter wire must be routed in a
continuous loop around the entire mowing
area.
Maximum length: 500 m
The robotic mower must not be
more than 35 m from the perimeter
wire at any point, as this would
prevent the wire signal being picked
up.
126
18.)
Route the perimeter wire starting at the
docking station. A distinction must be
9.1)
made between an internal docking
station and an external docking station
here.
Starting routing with an internal
docking station:
12.16)
Fasten the perimeter wire (1) to the ground
on the left or right as appropriate, next to
the floor plate, directly next to a wire outlet,
using a fixing pin (2).
Provide a free wire end (1) with a length of
approx. 1.5 m.
Route the perimeter wire (2) in front of and
behind the docking station (1) for 0.6 m in
a straight line and at right angles to the
floor plate. Then follow the edge of the
mowing area with the perimeter wire.
0478 131 9954 A - EN