Important Note - Medtronic MiniMed Mio Anleitung

E N G L I S H
Preparation and insertion
This product is an infusion device which combines an infusion set (catheter) with an aid for insertion
(inserter). This single-use, sterile product is delivered assembled and ready for use. Ensure sterility
by checking that the sterile paper and tamper-proof seal are not damaged. Carefully examine the
instructions for use before inserting this product. Refer to pump and reservoir user guides for
installation and priming. Please see the corresponding illustrations on pages 2 and 3.
Contents
A. Lid
B. Needle guard
C. Soft cannula
D. Adhesive
E. Cannula housing
F. Connector needle
G. Tubing
10

Important note!

H. Introducer needle K. Three raised dots – press here when lifting
I. Insertion device the lid off (see Figure 6)
J. Sterile paper L. Lined indentations – press here when
loading (see Figure 10)
M. Round Indentations – press here when
releasing (see Figure 12)
N. Disconnect cover (see Figure B)
Instructions
1 Wash your hands.
2 Recommended injection areas. Do not use an
area right next to your previous insertion site.
3 Clean the insertion area with a disinfectant
as directed by your healthcare professional.
Be sure the area is dry before inserting the
infusion set.
4 Pull the red tape to remove the protective
seal.
5 Remove the sterile paper.
6 With one hand hold the bottom of the insertion
device while pressing the three raised dots on
each side of the lid firmly with the other hand.
Lift up the lid.
CAUTION: Be careful not to bend or touch the
introducer needle when preparing the inserter
and infusion set.
7 Unwinding the tubing: Carefully twist the
beginning of the tubing out of the slot. Pull up
gently. Now unwind the tubing from the inser-
tion device by pulling it carefully upwards.
Caution: Do not touch the introducer needle
when unwinding the tubing. Be careful not to
pull too hard when the tubing is fully released.
You could accidentally remove the infusion
set from the introducer needle.