BigRep ONE Bedienungsanleitung Seite 61

Interface
BigRep ONE 5
case 180 °C). The temperature next to the white line indicates the desired value (in
this case 200 °C). After having loaded the data it indicates the recommended tem-
perature for the selected filament. (The temperature is derived from the G-Code).
You can manually change the desired value by moving the white line.
The orange slide controls allow you to manually extrude filament or to retract
filament from the extruder. The slide control on the left is for a slow feed, the slide
control on the right for a fast feed.
3
Indicates the status of the two extruders. Light gray: active (printing). Dark gray:
inactive (stand-by).
61