Disposal; Environmental Protection - BigRep ONE Bedienungsanleitung

BigRep ONE
Restarting After an Emergency Stop
Ensure the printer's operational readiness and particularly make sure that there
are no potential hazards for people.
To start the machine after an activated emergency stop, unlock the emergency
stop button by pulling it out. Then press Reset (T).
To start the machine after having activated the safety edge, press Reset (T).
In both cases the printer has to be restarted.
Uninterruptible Power Supply (UPS)
The integrated UPS in the control cabinet will provide power for a short amount of
time to correctly shut down the computer in case of a power outage. (Exception:
with the UPS supplied with the Advanced Kit, power supply to the computer con-
tinues for another 15-30 minutes. The printing process is paused).
Always make sure that the printer has been turned off for at least 30 seconds be-
fore starting it, allowing the UPS to fully discharge.

2.3. Disposal

CAUTION
Used UPS units may not be disposed of with domestic waste! Used lead-acid
batteries must be disposed of in accordance with local statutory regulations
for the disposal of batteries and battery material.
It is recommended that the disposal of the printer is performed by a specialist
disposal company. The regulations for waste disposal of the country in which the
printer is used in apply at the time of disposal. Users are obliged to comply with
waste disposal regulations.

Environmental Protection

Please follow the manufacturer's specifications for the disposal of filament.
Fig. 2-1: Emergency stop / safety edge
Safety
2
49