Electrical Safety; Initial Start-Up; Operation; Switching On And Off - Parkside PHLG 2000 F5 Originalbetriebsanleitung

people or animals.
• Do not look directly into the noz-
zle opening on the blow-off pipe.
• Do not touch the nozzle when it
is hot.
• Maintain distance between the
nozzle outlet and the surface or
workpiece you are working on.
The device could overheat.
Use as a solid fuel lighter / use
of the grill lighter nozzle (5)
• Check that the solid fuel lighter
is in the correct position.
• Isolate from the mains before
removing it from the fi re.
• Allow the solid fuel lighter to cool
down before packing it away.
• The connection cable or other
fl ammable materials must not
come into contact with the hot
parts of the solid fuel lighter.
Caution: This is how to avoid
accidents and injuries by an
electric shock:

Electrical safety

• Make sure that the mains volt-
age matches the details on the
type plate.
• Connect the device only to a
socket with a residual current
circuit breaker (Residual Current
Device) with a tripping current
of not more than 30 mA.
• Do not use the mains cable to
pull the plug from the socket.
Protect the mains cable from
heat, oil and sharp edges.
• Switch the device off and pull
the mains plug out of the socket
if the mains cable is damaged.
If the connection cable of this
device is damaged, it must be
replaced by the manufacturer
or their customer service or by
a similarly qualifi ed person in
order to avoid hazards.
• Do not connect a damaged
mains cable to the power sup-
ply. Do not touch a damaged
mains cable as long as it is
connected to the power supply.
A damaged mains cable can
result in voltage-carrying parts
being touched.

Initial start-up

When used for the fi rst time, some smoke
may escape. The smoke is caused by bind-
ers which are removed from the insulating
fi lm of the heater by the heat during fi rst
use. To ensure that the smoke escapes
quickly, the device should be placed on
the stand area. Be sure to ventilate the
working environment during fi rst use.
If the smoke/odour is too strong, move the
initial start-up to outside!

Operation

Switching ON and OFF

Change the step switch (3) to level "I". The
device reaches an air quantity of 330 l/min
at 350 °C.
Change the step switch (3) to level "II". The
device reaches an air quantity of 500 l/min
at 600 °C.
Change the step switch to level "0" to
switch it off.
GB IE CY
7