Operating Mode - Baumer N 214 Betriebsanleitung

Test end The test routine can only be terminated by switching off the device.
Test program version Press
Output test
➜ Press the
key.
The output is now activated. Reset the output using the
key.
Typical displays
Test the interface (where applicable)
Start key ; test O.K.:
Display: program number and version number.
Display: program date e.g. 20.11.96
Test for various input levels (operating points), signal forms and the
phase discriminator (test numbers 1 to 8).
As soon as the voltage supply has been switched on again the
device is in operating mode.
key, switch on the device (hold key down at the same
time).
Display: Program number and version number.
Display: Program date.

4 Operating mode

The operation and use of the device is described in this section.
● As soon as the voltage supply has been switched on the device
is automatically set to the operating mode.
In the operating mode:
- the current counter status can be read and reset.
Key functions
Key
Transfer to the next operating parameter.
Key
Transfer from programming to operating mode and vice versa.
Key
Select the irst or next required decade.
Key
Deletes the display if the
Key
When the key is pressed, the respective decade position advances
by one value until the maximum set value is reached.
www.baumer.com
; test failed:
key is enabled in line 30.
N 214
27