Baumer N 214 Betriebsanleitung Seite 29

Correct code unknown If the correct code is not known:
Correct code ➜ When the correct code has been input, press the
Change value entry ➜ Enter the corresponding value using the keys
Reset programming lines ➜ Press and hold the key
Line 21
Line 23
Line 24
Line 25
Line 26
➜ Return the counter to the factory.
● Access to programming lines in consecutive order. Value entry is
saved upon switching back from programming level to operator
level using the key
➜ Skip to next line using the key
forward run.
Factory setting is always marked with a *.
5.1 Programming field
Start count value
0 * Default
-999999 to 999999
Scaling factor
0 * 1.000
0.0001 to 9999.99
Decimal point
0 * no decimal point
1 00000.0
2 0000.00
3 000.000
4 00.0000
Counting mode
0 * Track A and up/down signal on track B
1 Differential counting (A-B)
2 Totalizing (A+B)
3 Track A 90º B, single evaluation
4 Track A 90º B, twofold evaluation
5 Track A 90º B, fourfold evaluation
● To set track A 90º B, the input frequencies for both tracks must
be adjusted to 10 kHz (line 26 and 27).
Frequency track A
0 * 10 kHz
1 25 Hz
2 3 Hz
www.baumer.com
.
. Press and hold key for fast
and press key
N 214
key.
and .
again.
29