Output Modes; Technical Data - Baumer N 214 Betriebsanleitung

N 214
count value
0
or SC
OUT
T T
W
W
count value
0
or SC
OUT
output signal related to zero –
value in display no time delay
count value
0
or SC
OUT
34

5.4 Output modes

The switching behaviour of the output is being determined by the
programmed parameters in the coresponding lines.
Parameter setting „0" (line 34 output time)
The output signal related to countvalue „0" or „offset SC" (see line
32) has a duration according to the time set in line 35.
t
T
W
Parameter setting „1" (line 34 output time)
The output signal related to countvalue „0" or „offset SC" (see line
32) stays activated as long as the countvalue „0" or „offset SC" is
being displayed.
t
Parameter setting „2" (line 34 output time)
The output signal related to countvalue „0" or „offset SC" (see line
32) stays activated as long as the countvalue „0" or „offset SC" is
being displayed but minimum for the time set in line 35.
t

6 Technical data

Technical data - electrical ratings
Voltage supply
Power consumption
Sensor supply
Display
Number of digits
Digit height
Function
Scaling factor
Count modes
Counting frequency
Measuring range
Data memory
Reset
Keylock
Outputs electronic
www.baumer.com
115/230 VAC ±10 % (50/60 Hz)
24/48 VAC ±10 % (50/60 Hz)
24 VDC ±10 %
7 VA, 5 W
12...26 VDC / max. 100 mA
LED, 7-segment display
6-digits
14 mm
Totalizer, Difference counter A-B,
Parallel counter A+B, Position display
0.0001...9999.99
Adding or subtracting
A-B difference (difference counting)
A+B total (parallel counting) up/down,
A 90º B phase evaluation
3 Hz, 25 Hz, 10 kHz programmable
-99999...+999999
>10 years in EEPROM
Button and electric
Yes, electric (keylock)
Optocoupler