Operating Mode; Key Functions - Baumer NE134 Betriebsanleitung

RS485 Half-duplex transmission with the following features:
Parameter reading Select the enabled parameters via the key
Resetting of counts 1. Display count of respective parameter.
Setting of parameters 1. Display parameter.
The interface parameters can be set on the programming level
(Lines 51, 52, 53 and 54).
- symmetrical
- 2 lines
- multi-point connection – emitter and receiver (max. 32 units)
- maximum distance of data transmission:1500 m
➜ Assign contacts 14 (T,R-) and 15 (T,R+) accordingly.
4

Operating mode

The following chapter will inform you on the operation.
● The counter is automatically on the operator level after the supply
voltage has been turned on.
On the operator level it is possible
- to read and, if necessary, clear the current count;
- to read and, if necessary, modify the presets P1 and P2;
- to read and, if necessary, modify the preset start count;
- to read and, if necessary, clear the totalizer;
- to read and, if necessary clear the batch counter;
- to read and, if necessary, modify the scaling factor.
It is possible to disable all operator parameters on the programming
mode (lines 11-17).
4.1

Key functions

The key allows to switch to the next operation parameter.
For quick sweep, keep this key depressed.
2. Press key .
2. Press or key and select required decade;
chosen decade position blinks.
3. Press or key and enter required value.
To set further decades, repeat steps 2 and 3.
4. Confirm the parameter entered with
Should no confirmation be given within 15 s, the previous setting
will remain valid.
www.baumer.com
NE134
or .
.
31