Baumer N 214 Betriebsanleitung Seite 31

Line 52
Line 53
Line 54
Line 67
To leave programming ➜ Press the
Reprogramming the device ➜ Press and hold the
with the default setting
Parity
0 * Even parity
1 Odd parity
2 No parity
Stop bits
0 * 1 Stop bit
1 2 Stop bits
Address
0 * Default
0 to 99
At the end of these programming lines a dashed line will appear in
the display, signifying the completion of the programming segment.
mode ● The device now reverts to the operating mode.
the same time.
● All the programmed values will now revert to their default
settings. The message „ClrPro" appears briely in the display.
www.baumer.com
(7 data bits)
(7 data bits)
(8 data bits)
key.
and keys and switch on the device at
N 214
31