Programming Mode - Baumer N 214 Betriebsanleitung

N 214
Enter code Enter the code with the keys
Incorrect code If an incorrect code has been input:
28

5 Programming mode

In the programming mode all the machine-related functions and va-
lues can be programmed, together with the interface parameters.
Key functions
The same key assignments apply to the individual programming seg-
ments. Since key functions may vary in the operating and program-
ming mode.
Key
Transfer to the next operating parameter. For a fast run-through hold
the key down (in programming mode only).
Key
Transfer from programming to operating mode and vice versa.
Key
Select the irst or next required decade The selected decade
position lashes.
Key
Deletes the display. Value reset to zero. Reset of possible program-
med operating parameters.
Key
When the key is pressed, the respective decade position advances
by one value until the maximum set value is reached.
To access programming
➜ Press the
key
● The system transfers from the operating to the programming
mode.
is displayed.
The code applies to programming segment.
Press the key to acknowledge.
No code is entered before delivery.
●
appears in the display when the
● After 15 seconds, the system will automatically revert to the
operating mode.
➜ Press the
key.
➜ Input the correct code.
www.baumer.com
and .
key is pressed.