Baumer N 214 Betriebsanleitung Seite 21

N 214
Operation not covered by the speciied descriptions/parameters is
improper and can lead to
- fatal injuries,
- serious damage to health,
- property damage or
- damage to the units
in conjunction with the systems/machines/processes to be
controlled/monitored!
The overvoltages to which the units are subjected at the connection
terminals must be limited to the value of the overvoltage category II
(see Technical data)!
The units may not be operated
- in hazardous areas,
- as medical units,
- in applications expressly named in EN 61010!
If the units are used to control/monitor machines or processes with
which, as the result of a failure/malfunction or incorrect operation of
the units
- a life-threatening danger,
- health risks or
- a danger of property or environmental damage
could result, then appropriate safety precautions must be taken!
Do not open the housing of the units or make any changes to it!
Tampering with the units can have a negative affect on their opera-
ting safety, resulting in dangers!
Do not make repairs on the units! Return defective units to the
manufacturer!
Installation/commissioning
In case of changes (including in the operating behavior) that impair
safety, shut-down the units immediately. During installation work on
the units, the power supply must always be disconnected. Installati-
on work may only be carried out by appropriately trained experts.
Maintenance/repairs
Always disconnect the power supply of all units involved. Main-
tenance and repair work may only be carried out by appropriately
trained experts.
If troubleshooting is unsuccessful, do not continue to use the units.
Please contact the manufacturer in this case.
www.baumer.com
21