Connecting The Transmitter; Inserting Batteries Into The Receiver; Fastening The Receiver And Connecting The Earphones - Omnitronic IEM-500 Bedienungsanleitung

5.3 Connecting the transmitter

1
Connect the signal source(s) with line level (e.g. stereo output or monitor outputs of a mixing console)
via balanced XLR or 6.3 mm plugs to the inputs LEFT INPUT and RIGHT INPUT. If only an unbalanced
signal is available it may be connected to the input jacks by means of 6.3 mm mono plugs.
Note: In mono mode, only the input signal of the right channel will be sent.
2
To monitor the audio signal directly on the transmitter stereo headphones can be connected to the
6.3 mm jack PHONES.
3
Insert the supplied antenna into the rear BNC jack ANTENNA or mount it to the front panel via the
supplied antenna cable ( s. section 5.2 Mounting the antenna at the front panel). Set up the antenna in
a vertical position.
4
Finally, connect the power supply unit to the power input of the transmitter and the mains plug to a
mains socket. Use the transmitter only with the supplied power unit. Always disconnect the mains
connector when you wish to change connections, move the unit to a different place or if it is not used for
a longer period.

5.4 Inserting batteries into the receiver

1
For operation, the receiver requires two 1.5 V mignon batteries. Unfold the front cover and insert the
supplied batteries as indicated in the battery compartment.
2
The capacity of the batteries is indicated on the display:
With new batteries, the receiver can be operated for approx. 5 hours. If the battery indicator lights up
and the battery icon on the display starts flashing the batteries are going flat and the receiver switches
off automatically within a short time.
3
If the receiver is not used for a longer period (approx. 1-2 weeks), please remove the batteries to
prevent damage in case of battery leakage. Please refer to further explanations in chapter Safety
Instructions.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty battery in accordance with the instructions of the manufacturer.
Batteries are hazardous waste and should not be disposed of with regular domestic waste!
Please take discharged batteries to a collection center near you.

5.5 Fastening the receiver and connecting the earphones

1
Attach the receiver via the belt clip to your belt or strap on your instrument (
the right). When using a wireless microphone or a transmitter for a musical instrument
at the same time, do not place the devices side by side but place them apart in order
to avoid interference. It will sufficient to place one device on the right side and one on
the left side of your body.
2
Connect the supplied earphones to the 3.5 mm jack on the receiver.
3
For optimum fit of the earphones, delivery includes three pairs of silicone sleeves of different sizes.
Insert the earphones for the left ear marked L and for the right ear marked R into your ears and lead the
cable over your outer ear to the back of your head. This will ensure a tighter fit than leading the cable
directly downwards.
CAUTION!
Danger of explosion when battery is replaced improperly.
BATTERY DISPOSAL NOTICE
Please dispose of discharged batteries properly.
27/32
s. fig. to
00052812.DOC, Version 1.2