Setting Into Operation; Placing The Receiver Or Installing The Receiver In A Rack; Mounting The Antenna At The Front Panel - Omnitronic IEM-500 Bedienungsanleitung

5. SETTING INTO OPERATION

5.1 Placing the receiver or installing the receiver in a rack

For best transmission quality place the transmitter at the height of the receiver and avoid obstacles between
the transmitter and the receiver, e.g. metal, dense materials, computers or other RF generating equipment
(at least 50 cm distance). The transmitter also should have a distance of approx. 1 m from lateral walls.
For 483 mm rack installation (19"), one unit (1 U) is required. Screw on the two mounting brackets at the left
and right sides of the housing (
is enough space around it so that the heated air can be passed on. Steady overheating will damage your
device. You can fix the unit with four screws M6 in the rack ( fig. 2).

5.2 Mounting the antenna at the front panel

1
For mounting the antenna at the front, insert the supplied BNC double jack through the corresponding
left or right mounting hole on the front panel and screw it on.
2
Connect the BNC jack to the rear antenna input via the supplied antenna cable. Then insert the supplied
antenna into the front BNC jack and set it up in a vertical position.
fig. 1). When mounting the unit into the rack, please make sure that there
26/32 00052812.DOC, Version 1.2