Setting Into Operation; Placing The Receiver Or Installing It In A Rack; Connecting The Receiver - Omnitronic UHF-204 Bedienungsanleitung

6. SETTING INTO OPERATION

6.1 Placing the receiver or installing it in a rack

Install the receiver on a plane surface or in your rack. For 19" (483 mm) rack installation, 1 unit is required.
Screw on the two mounting brackets at the left and right sides of the housing. When mounting the unit into
the rack, please make sure that there is enough space around it so that the heated air can be passed on.
Steady overheating will damage your device. You can fix the unit with four screws M6 in the rack.

6.2 Connecting the receiver

1 Insert the two supplied antennas into the TNC jacks and put them in a vertical position.
Connect the receiver to the subsequent unit:
2
• The balanced XLR outputs of the individual channel outputs "CH-1" to "CH-4" can be connected to a
microphone input each of a mixer.
• Use the unbalanced 6.3 mm jack "MIX OUT" for the master signal of all receiving channels for
connection to a microphone input or a highly sensitive line input via the supplied connection cable.
Finally, connect the power supply unit to the power input of the receiver and the mains plug to a mains
3
socket. The power cable can be secured to the unit via the strain relief.
Use the receiver only with the supplied power unit. Always disconnect the mains connector when you
wish to change connections, move the unit to a different place or if it is not used for a longer period.
16/19 00074640.DOC, Version 1.0