Inserting / Replacing Batteries; Description Of The Device; Connections; Operation - Omnitronic VHF-200 Bedienungsanleitung

Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.

4. CONNECTIONS

Connect the wireless receiver via the Audio Out-socket and a standard microphone lead with a microphone
input socket of your mixer.
Adjust the antenna vertically.
Plug the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet.
Inserting/Replacing batteries
Please refer to the explanations under Operating Determinations.
Open the battery cover on the bottom and remove it.
If replacing the batteries, remove the old batteries from the battery compartment. Only replace complete
battery-sets.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty batteries in accordance with the instructions of the manufacturer.
Insert the battery (1 standard 9 V battery) and make sure that the poles are correct.
Replace the battery cover and close it.

5. OPERATION

With the ON/OFF-switch, you can switch the device on and off. When switching the device on, the red LED is
illuminated.
If microphone signals are being received, the RF-LED is illuminated.
For optimum receiving please follow these instructions:
• Maintain a line-of-sight between the transmitter and receiver antennas, if possible. Avoid placing
transmitter and receiver where metal or other dense materials may be present.
• Avoid placing the receiver near computers or other RF generating equipment.
• The Squelch-control is factory preset at the 12 o'clock position for optimum performance. No further
adjustment is normally required. However, it is possible to adjust the squelch control to emphasize either
signal quality or system range.
To raise the squelch threshold, rotate the control clockwise. This causes the receiver to demand a higher
quality signal (less noise before muting), but it reduces the operating range.
To lower the squelch threshold, rotate the control counterclockwise. This allows a lower quality signal
through (more noise before muting), but it extend s the operating range.
Adjust the signal output level via the Volume-control.
If the receiver is no longer used, please turn the Volume-control to 0 and switch the device off.
Danger of explosion when battery is replaced improperly.
Caution!
10