Setup And Operation; Placing The Receiver; Connecting The Receiver; Hand-Held Microphone And Pocket Transmitter - Omnitronic UHF Serie Bedienungsanleitung

4 4 4 4 Setup and Operation

4.1 Placing the receiver

Place the receiver on an even surface and connect the antennas provided to the antenna jacks. Put the
antennas upright in a V-shaped position. For 19" rack installation (483 mm) mounting brackets are provided.
Fasten the brackets at the left and right sides of the housing. In order to ensure sufficient cooling of the unit,
air must always be able to flow freely through all air vents.
Notes
• Place the receiver at least 1 meter above the ground and not too close to lateral walls.
• Avoid sources of interference such as metal surfaces or electronic devices (e.g. computer, CD player).
• Ideally, position the receiving antennas at the height of the transmitter. When using multiple systems, do
not allow antennas to cross or touch each other.
• For optimum reception, keep the transmitter at least 1 meter away from the receiver and avoid obstacles.

4.2 Connecting the receiver

1) Connect the receiver to the subsequent unit:
• The unbalanced XLR outputs of the individual channel outputs can be connected to a microphone input
each of a mixer.
• Use the unbalanced 6.3 mm jack "MIX OUT" for the master signal of all receiving channels for
connection to a microphone input or a highly sensitive line input.
2) Finally, connect the power adapter to the power input of the receiver and the mains plug to a mains
socket. Use the receiver only with the supplied power adapter. Always disconnect the mains connector
when you wish to change connections, move the unit to a different place or if it is not used for a longer
period.

4.3 Hand-held microphone and pocket transmitter

1) For operation, the hand-held microphone and the pocket transmitter require two 1.5 V AA batteries each.
To access the battery compartment unscrew the lower part of the microphone. In case of the pocket
transmitter, fold up the front cover. Insert two batteries as indicated in the battery compartment.
2) The capacity of the batteries is indicated in the display in several steps. Replace the batteries when the
battery icon shows one bar. If the devices are not used for a longer period, please remove the batteries
to prevent damage in case of battery leakage.
3) Attach the pocket transmitter with the belt clip to your clothing or strap on your instrument. Connect the
microphone or instrument cable to the mini XLR input. The sensitivity for the input can be adjusted in the
setting menu.
19 • EN