Profitec Pro 500 Bedienungsanleitung Seite 22

Below you find a table that indicates the set steam temperatures and the resuling extraction temperatures
according to a measurement series with consistent parameters. At the time of coffee extraction, the machine
was on for 20-30 minutes.
This table can be used as a general guidance. However, please note that the temperature values indicated
in the table may differ from the actual temperature values due to parameters such as ambient temperature,
time of use of the machine since it has been switched on, extraction time of the coffee, possible lime
residues etc..
Technically, the boiler temperature can be set between 80° and 128°C (between 176°F and 262°F). In the
table, only the recommended boiler temperature interval from 116 to 124°C (from 240,8 to 255,2°F) is
indicated.
Boiler temperature at the measuring
Extraction temperature at the brew
Boiler temperature at the measuring
Extraction temperature at the brew
To adjust the temperature please follow the instructions below:
1. Switch the machine on. The temperature of the boiler is of no importance
in programming. The heater is inactive during programming.
+
2. Press
display.
+
3. Press
temperature value. The nominal temperature value is displayed.
4. Quickly press
–
to decrease
+
to increase
the nominal temperature value.
5. Please wait a short while after having set the nominal temperature value;
't1' will be displayed.
–
6. Press
Bedienungsanleitung / Instruction manual Profitec Pro 500
Downloaded from www.Manualslib.com
°C
point/display
°C
group
°F
point/display
°F
group
–
at the same time until 't1' appears on the
and
in order to progress to the submenu of 't1' and to change the
in order to leave the programming mode.
manuals search engine
116,0 117,0 118,0 119,0
89,9 90,4 90,9 92,3
recommended
240,8 242,5 244,4 246,2
193,8 194,7 195,6 198,1
21
120,0 121,0 122,0 123,0
93,4 93,9 94,8 95,5
248,0 249,8 251,6 253,4
200,1 201,0 202,6 203,9
124,0
96,2
255,2
205,2