Troubleshooting - Profitec Pro 500 Bedienungsanleitung

11 TROUBLESHOOTING

Problem
Little or no crema on top of the
coffee
Sparse coffee dispensing, only
drop by drop
The machine is switched on, but
the machine does not work.
Machine does not heat anymore,
the temperature falls off.
Weak "body"
Coffee is too cold.
Coffee is too cold, also after I
modified the set temperature via
the display.
Foam instead of crema
Bedienungsanleitung / Instruction manual Profitec Pro 500
Downloaded from www.Manualslib.com
Possible cause
The grind is not fine enough
The coffee is too old.
There is too much chlorine in the
water.
The amount of ground coffee is
not enough.
The shower screen is dirty.
The grind is too fine.
There is too much ground coffee.
The orange control lamp is
switched off: there is not enough
water in the water tank.
Water was refiled, the orange
control lamp is switched off.
The water tank is not fixed
properly.
Is it possible you did not exit the
programming menu on the
display?
The grind is not fine enough.
The coffee is old.
The amount of ground coffee is
not enough.
The shower screen is dirty.
The set temperature is too low.
The machine is possibly calcified.
The coffee beans are improper
The setting of the coffee grinder is
not suited for the coffee beans in
use
manuals search engine
Troubleshooting
Use a finer grind setting.
Tamp the ground coffee more
firmly.
Use fresh coffee
Use a chlorine filter.
Use the right coffee amount:
Approx. 7 g – 9 g of coffee for
each cup.
Clean the brew group.
Increase the grind setting.
Tamp the ground coffee only
slightly.
Use approx. 7 g – 9 g of coffee for
every cup.
Refill water.
Switch on/off the machine.
Make sure that the floater in the
water tank is in the correct
position. (The side of the floater
with the magnet point should face
towards the inside of the machine.
The floater itself should be
inserted with the magnet point on
the upper part of the floater side.)
Fix the water tank properly.
–
Press
programming mode.
Reduce the grind setting.
Use fresh coffee.
Use approx. 7 g of coffee for each
cup.
Clean the shower screen.
Increase the temperature via the
PID display (see chapter 6.2)
Please have the machine
decalcified by your specialised
dealer.
Use another coffee bean.
Adjust the coffee grinder (When
changing the coffee beans,
changing the grind may also be
necessary.)
27
in order to leave the