PeakTech 1070 Bedienungsanleitung Seite 33

4.5. Continuity test
1. Connect the black test lead to the COM-jack and the red test lead
2. Set the function switch to
3. In continuity testing if continuity exists (i.e. resistance less than
CAUTION! Never perform a continuity measurement on a circuit that
has power connected!
4.6. Diode
1. Connect red test lead to "V//mA" jack, black test lead to "COM"
2. Set the FUNCTION switch to the
Downloaded from www.Manualslib.com
to the V//mA-jack. (Note: The polarity of the red lead connection
is positive "+")
about 20 to 150) built-in buzzer will sound.
jack.
the red test leads to the anode of diode and black to cathode.
The display will then show the approx. forward voltage of this
diode. If connect the test leads on the other way round, the
display will show an overrange status "OL"
manuals search engine
)
)
) /Diode position.
°
))) position and connect
*
-32-