Adjusting The Tool Rests; Fitting The Spark Deflectors; Fitting The Eye Shields; Working Procedures - Parkside PDFW 120 A1 Originalbetriebsanleitung

♦ Now use the knurled screw
workpiece rest firmly onto the device. Ensure
that the spring washer and washer are properly
fitted (see fig. B).

Adjusting the tool rests

♦ Adjust the workpiece rests
the knurled screws
between the grinding
and the tool rest
Ensure that the workpiece rests
into contact with the grinding
discs .
♦ Adjust the distance repeatedly as the grinding
or buffing disc
Fitting the spark deflectors
♦ Fit the spark deflectors
fixing bolts for the spark deflectors
washers and spring washers to the top of the
device (see fig. C).
♦ Tighten the nuts using a pair of pliers or a 7 mm
open end wrench. Tighten the fixing bolts for
the spark deflector
driver.
♦ Fit the spark deflectors
between the grinding
the spark deflector
The gap should not be greater than 2 mm.
Ensure that the spark deflectors
into contact with the grinding
discs .
♦ Adjust the distance repeatedly as the grinding
or buffing disc

Fitting the eye shields

♦ Attach the eye shields
ed on the spark deflectors using the mounting
screws for the eye shields
spring washers (see fig. C).
♦ Tighten the nuts using a pair of pliers or a 8 mm
open end wrench. Tighten the fixing bolts for
the eye shields using a Phillips screwdriver.
PDFW 120 A1
to attach the
with the aid of
. Ensure that the space
or the buffing disc
is as low as possible.
do not come
or the buffing
wears down.
with the aid of the
, nuts,
using a Phillips screw-
so that the distance
or buffing disc and
is as small as possible.
do not come
or the buffing
wears down.
to the fixtures provid-
, nuts, washers and

Working procedures

Ensure that the appliance is always stable
and secure.
Ensure that the grinding
are not blocked.
Ensure that the eye shields
tors and tool rests
and adjusted!
A light grinding pressure is sufficient:
Work using a light grinding pressure – a constant
and correct speed will ensure the best grinding
performance.
Grinding:
Bear in mind that the workpiece heats up during
grinding. Therefore, cool the workpiece in a water
bath. Dry it thoroughly before you resume working.

Operation

Switching on and off
■ Direction of rotation of the tool!
NOTE
► Before first use, allow the grinding
ing discs to run without a load at top speed
for about 5 minutes. When doing so, stay out of
the hazard area in front of and next to the open-
ings in the grinding
WARNING – RISK OF INJURY!
► Ensure the lowest-possible distance (gap)
between the grinding
and the tool rest
► If the appliance suddenly brakes completely
or jams, it must be switched off immediately.
♦ Set the eye shields
greatest possible protection.
♦ Switch the appliance on by pressing the ON/
OFF switch .
♦ Set a speed suitable for the work using the
speed control .
♦ Switch the appliance off by pressing the ON/
OFF switch again.
GB │ IE │ NI │ CY
and buffing discs
, spark deflec-
are properly fitted
and buff-
or the buffing disc .
or the buffing disc
.
so that they provide the
│
11 ■