Positioning The Workpiece / Tool Rests And Eye Guard Mounts; Preparing For First Use; Switching On And Off; Grinding A Workpiece - Parkside PDOS 200 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Before use / Preparing for first use
four mounting holes
(not supplied). Refer to Figure C.
© Positioning the workpiece / tool
rests and eye guard mounts
To ensure safe working, the workpiece / tool rests
the eye guards
must be correctly positioned.
Check and correct the settings at frequent intervals
to ensure even wear on the grinding wheels
Adjusting the workpiece / tool rests:
1) To adjust the setting, first loosen the adjuster
screw
6
2) Bring the workpiece / tool rest
the grinding wheel
the grinding wheel
tool rest
3) Retighten the adjuster screw
using your hand that the grinding wheel
movement is true and free.
Adjusting the eye guard mounts:
1) To adjust the setting, first loosen the fastening
screw
14
2) Bring the eye guard mount
grinding wheel
grinding wheel
must be no more than 2 mm.
3) Retighten the fastening screw
using your hand that the grinding wheel
movement is true and free. A worn out grinding
wheel 4
when the specified gap cannot be achieved even
after readjusting the positions of the workpiece /
tool rest
© Preparing for first use
© Switching on and off
Switching on:
Press the ON / OFF switch
position to switch the device on and run it
at a constant speed.
10 GB/IE
Downloaded from www.Manualslib.com
and suitable fixings
8
and the eye guard mounts
3
.
5 close up to
, the distance between
4
and the workpiece /
4
must be no more than 2 mm.
5
6 and check
.
2 close up to the
, the distance between the
4
and the eye guard mount
4
and check
14
needs to be replaced. This is necessary
5 and / or the eye guard mount
into the "1"
9
manuals search engine
Switching off:
Press the ON / OFF switch
position to switch the device off.
©

Grinding a workpiece

, NOTE: Use the fine grinding wheel for precise
5
grinding tasks (grade "A80M").
2
NOTE: Use the coarse grinding wheel for rough
grinding tasks (grade "A36M").
.
4
Switch on the machine as described above.
To grind metal tools or metal items, place the
workpiece on the workpiece / tool rest
slowly bring it up to the grinding wheel
Press the workpiece carefully against the grind-
ing wheel
4
the device. When grinding always use the
circumferential end face (not the sides) of the
grinding wheel only (See Figures D, E, F).
4
©

Replacing a grinding wheel

WARNING!
carrying out any tasks on the device itself and
when you are not using the device, always pull the
mains plug out of the mains socket.
2
½
Do not use damaged grinding wheels.
½
Only use grinding wheels with details that cor-
respond with those given on the device rating
4
plate. The circumferential speed should be
equal to or greater than the value given on the
device rating plate.
Only grinding wheels with markings indicating
2 . the manufacturer, the type of adhesive, dimen-
sions and permitted circumferential speed are
to be used. If you install new grinding wheels
carry out a ringing test before use. Grinding
wheels in good condition give a clear ringing
noise when struck lightly with a plastic hammer.
1) Take off the outer part of the wheel guard cov-
er by unscrewing the 3 threaded fixings
7
(see Figs. N, O).
into the "0"
9
. Pressing too hard can overload
RISK OF INJURY! Before
and
5
.
4